Installing Rear Connecting Link (PDCC Actuator)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit connecting link on anti-roll bar. Initial tightening 50 Nm (37 ftlb.) Final tightening +50°
Fit connecting link on wheel bearing housing. Initial tightening 50 Nm (37 ftlb.) Final tightening +50°
Clip lines into the plastic holder.
Fit upper and lower pressure line, together with new double seals on the connecting link. Do not confuse the banjo bolts!
Fit banjo bolt (with check valve) -1- on the lower pressure line. Secure upper pressure line with a conventional banjo bolt -2- . Tightening torque 26 Nm (19 ftlb.)

Fig 1: Identifying Pressure Lines Banjo Bolts
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Differentiating banjo bolts
1. Banjo bolt with check valve for lower pressure line
2. Conventional banjo bolt for upper pressure line
  
  Fig 2: Identifying Banjo Bolts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.