Technical Values
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Pressure line to valve block | M14 x 1.5 thread | Tightening torque | 28 Nm (21 ftlb.) | ||
| Subframe to front body | M12 x 1.5 x 75 thread | Tightening torque | 90 Nm (67 ftlb.) | +90° | |
| Subframe to rear body | M12 x 1.5 x 75 thread | Tightening torque | 90 Nm (67 ftlb.) | +90° | |
| Engine mount to subframe | M10 x 80 thread | Tightening torque | 65 Nm (48 ftlb.) | ||
| Brake calliper to wheel carrier | M14 x 1.5 thread (always replace screws and lock nuts after removal.) | Tightening torque | 140 Nm (104 ftlb.) | ||
| Upper wishbone to tapered end of wheel carrier | M12 x 1.5 thread | Tightening torque | 85 Nm (63 ftlb.) | ||
| 4 Front - Support for front axle and crash support to body | M12 x 1.5 x 130 thread | Tightening torque | 90 Nm (67 ftlb.) | +180° | |
| 4 Rear - Vibration strut (transverse strut) with support for front axle to body | M12 x 1.5 x 58 thread | Tightening torque | 90 Nm (67 ftlb.) | +90° | |
| Support for front of front axle to subframe | M8 x 20 thread | Tightening torque | 33 Nm (24 ftlb.) | ||
| Drive shaft to differential | M8 x 53 thread | Tightening torque | 22 Nm (16 ftlb.) | +90° | |
| Lower wishbone to spring strut | M12 x 1.5 thread | Tightening torque | 90 Nm (67 ftlb.) | +120° | |
| Steering spoiler (air guide) to lower wishbone with take-up hole | M6 x 50 thread | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Universal joint to steering gear | M8 x 30 thread | Tightening torque | 20 Nm (15 ftlb.) | +90° | |
| Heat shield to steering gear | M6 x 12 thread | Tightening torque | 10 Nm (7.5 ftlb.) |