Replacing Subframe

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Install at the correct position and check that all accessories are installed. Document installation by taking photos if necessary (assembly aid!).

Remove front axle support at rear and anti-roll bar (watch out for the lines for anti-roll bars with PDCC!).
Remove mounting for anti-roll bar (crash element, anti-roll-bar mount).
Remove steering gear.
Remove lower trailing arm with wheel bearing housing and drive shaft.
Remove bulkhead plate (heat protection panel) on the left/right.
Remove steering return line.