Removing charge-air cooler

Information 

The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.

1. Remove air guide -1-  on the charge-air cooler -2-  .
2. Disconnect pressure hoses on the charge-air cooler.
   1. 2.1. Release locking spring -1-  and pull off pressure hose -2-  at the bottom of the charge-air cooler -3-  .
   2. 2.2. Loosen screw-type clamp -4-  and pull off pressure hose -5-  at the top of the charge-air cooler -3-  .
3. Loosen clamp -1-  and pull ambient air line -2-  off the wastegate -3-  .
4. Remove charge-air cooler.
   1. 4.1. Unscrew screws -1-  .
   2. 4.2. Remove charge-air cooler -2-  by pulling it forward.