Installing Mounting Unit

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Fit square nut that is further away from the bore with respect to the edge up into the bracket.

Push drive shaft -1- of the mounting unit -2- into the guide tube.

Fig 1: Pushing In Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install mounting unit -1- in the assembly frame -arrow- .

Fig 2: Installing Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit outer -1- and inner -2 - fastening screws at the front and tighten hand-tight.

Fig 3: Installing Front Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit rear fastening screws -1- and tighten hand-tight.
1. 4.1. Position retaining bracket -3- and tighten fastening screw -2- hand-tight.
  
  Fig 4: Identifying Rear Mounting Unit
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit fastening screws -1- used to secure the mounting unit to the assembly frame at the sides and tighten hand-tight.

Fig 5: Securing Mounting Unit Frame Assembly
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert wiring harness -1- into the guide rail -2- .

Fig 6: Identifying Wiring Harness For Electric Drive
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push mounting unit -1- at the left and right onto the rear lock with your hand.

Fig 7: Pushing Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position metal clip -1- and engage it in the mounting.

Fig 8: Identifying Metal Clip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install safety clip -1- .

Fig 9: Identifying Safety Clip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws to the specified torque.
Fastening screw for outer front mounting unit. Tightening torque 3 Nm (2 ft. lbs.)
Fastening screw for inner front mounting unit. Tightening torque 3 Nm (2 ft. lbs.)
Fastening screw for rear mounting unit. Tightening torque 3 Nm (2 ft. lbs.)
Fastening screw securing retaining bracket to guide tube. Tightening torque 3 Nm (2 ft. lbs.)
Fastening screw securing mounting unit to assembly frame. Tightening torque 3 Nm (2 ft. lbs.)