Installing Door Entry Guard
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Pay particular attention to the following:
- Check that the door entry guard is fitted exactly. Check gap and joint dimensions.
- Tighten fastening screw securing rear wheel housing liner to the body to the specified torque. Tightening torque 2 Nm (1.5 ftlb.) +10 % -15 %
- Tighten fastening screw for front wheel housing liner to the specified torque. Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 %
- Tighten rear fastening screw for underside to the specified torque. Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 %