Installing Air-Conditioning Compressor
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refrigerant
- Danger of freezing
→ Avoid contact with refrigerant.
→ Wear personal protective gear.
→ Observe the safety regulations for working on air-conditioned vehicles and dealing with refrigerant.
→ Observe the safety regulations for extraction and filling systems.
→ Observe the instructions for repairing air conditioning systems and storing spare parts.
- Install air-conditioning compressor -1-
.
- 1.1. Position air-conditioning compressor -1- with screw -4- in the engine compartment.
- 1.2. Tighten fastening screw (M8 x 170) -4- . Tightening torque 23 Nm (17 ft.lbs.)
- 1.3. Position holder -3- with fastening screws (M8 x 90) -2- and tighten screws. Tightening torque 23 Nm (17 ft.lbs.)
- Close the air-conditioning lines -1-
.
- 2.1. Remove stoppers.
- 2.2. Replace O-rings and coat the new rings with refrigerant oil.
- 2.3. Tighten M8 fastening screws -2- Tightening torque 22 Nm (16 ft.lbs.) on the high-pressure and low-pressure lines and counter with assembly tool 9822 while doing this.
- 2.4.
- Connect electric plug connection for air-conditioning compressor.
WARNING:
Refrigerant
- Danger of freezing
→ Avoid contact with refrigerant.
→ Wear personal protective gear.
→ Observe the safety regulations for working on air-conditioned vehicles and dealing with refrigerant.
→ Observe the safety regulations for extraction and filling systems.
→ Observe the instructions for repairing air conditioning systems and storing spare parts.
- Install air-conditioning compressor -1-
.
- 1.1. Position air-conditioning compressor -1- with screw -4- and holder in the engine compartment.
- 1.2. Tighten fastening screw -4- . Tightening torque 23 Nm (17 ft.lbs.)
- 1.3. Tighten fastening nut -4- securing holder to throttle housing. Tightening torque 6 Nm (4.5 ft.lbs.)
- 1.4. Position holder -3- with fastening screws (M8 x 90) -2- and tighten screws. Tightening torque 23 Nm (17 ft.lbs.)
- Connect high-pressure and low-pressure lines -1-
.
- 2.1. Remove stoppers.
- 2.2. Replace O-rings and coat new rings with refrigerant oil.
- 2.3. Tighten fastening screws -2- on the high-pressure and low-pressure lines -1- and counter with assembly tool 9822 while doing this. Tightening torque 22 Nm (16 ft.lbs.)
- Connect electric plug connection for air-conditioning compressor.