Installing Distributor Housing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Grease O-rings, hoses and lines in the cooling system with Kluberplus Gel (Part No. 000.043.205.93) .

Check molded seals and replace if damaged.
1. 1.1. Coat seals with the specified lubricant.
Install distributor housing -1- .
1. 2.1. Position distributor housing.
2. 2.2. Tighten all screws.
3. 2.3. Fit coolant connection piece and tighten external Torx screws (M8 x 70) -2- .
  Tightening torque 33 Nm (24 ftlb.)
4. 2.4. Tighten external Torx screws M8 x 50 -3- and M8 x 35 -4- .
  Tightening torque 33 Nm (24 ftlb.)
  
  Fig 1: Identifying Coolant Distributor Housing Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure bracket -1- for coolant pump.
1. 3.1. Tighten external Torx screws -4 and 5- .
2. 3.2. Tighten M6 external Torx screw.
  Tightening torque 13 Nm (9.5 ftlb.)
3. 3.3. Tighten M8 external Torx screw.
  Tightening torque 33 Nm (24 ftlb.)
  
  Fig 2: Identifying Coolant Pump Bracket (Engine Carrier)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install vibration damper.
→ INSTALLING VIBRATION DAMPER .
Install tensioning roller.
→ INSTALLING TENSIONING ROLLER .