LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Cayman Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (42 - Rear Wheel Suspension, Drive Shafts -- CARRERA (997)) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Wheel Carrier) (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

The drive shaft should only be loosened at the wheel bearing housing if the wheel bearing or wheel bearing housing needs to be replaced.

Loosen axle nut (vehicle on ground and brakes operated by 2nd fitter).

  1. If necessary (if the wheel bearing or wheel bearing housing was replaced), loosen the drive shaft at the wheel bearing housing (loosen axle nut).
  2. Raise the vehicle → 400000 LIFTING THE VEHICLE .
  3. Remove wheel → REMOVING WHEEL .
scientia non olet · About LEMON Manuals