Removing Top Inner Rear Axle Cross Member

Grind down MIG seams.

Fig 1: Identifying Rear Trunk Floor Panel MIG Seams
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Drill out spotwelds using Spotweld Drill .

Fig 2: Identifying Rear Trunk Floor Panel Drill Out Spotwelds
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Drill out spotwelds through two plate thicknesses.

Fig 3: Identifying Rear Trunk Floor Panel Drill Out Spotwelds
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Drill out spotwelds.

Fig 4: Identifying Rear Trunk Floor Panel Drill Out Spotwelds
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Heat up connection areas using a hot-air gun.

Fig 5: Identifying Rear Trunk Floor Panel Heat Up Connection Areas
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove top inner rear axle cross member.