Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Transmission Bracket To Manual Transmission | Hexagon-Head Bolts, M10 x 1.5 x 55 With 20-mm Spacer Sleeves/Always Use New Bolts Following Removal | Initial Tightening | 30 Nm (22 ft. lbs.) | ||
| Transmission Mount (Hydraulic Mount) To Transmission Bracket (All Versions) | Torx Nut M12 x 1.5/The Tightening Torque Must Be Supported Using A Open-Ended Wrench On The Face Of The Transmission Bracket (Outside On The Welded-On Bush) | Tightening Torque | 85 Nm | ||
| Transmission Mount (Hydraulic Mount) To Rear-Axle Carrier Side Section (All Versions) | M8/Differing Screw Lengths Depending On Variant (Note Allocation In PET) | Tightening Torque | 33 Nm |