Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic Value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Drive Shaft To Transmission Flange (PDK And Manual Transmission) | Cheese Head Bolt M10 x 46.5 x 12.9 | Tightening Torque | 80 Nm | ||
| V-Strut (Rear Transverse Strut) To Body | Hexagon-Head Bolt, M10 x 1.5 x 55/Always Replace Following Removal | Initial Tightening | 35 Nm (26 ft. lbs.) | ||
| V-Strut (Rear Transverse Strut) To Body | Hexagon-Head Bolt, M10 x 1.5 x 55/Always Replace Following Removal | Final Tightening | +60° | ||
| Transmission Flange To Engine | Screw, M12 x 1.5 x 55 - Observe Specified Tightening Sequence | Tightening Torque | 85 Nm (63 ft. lbs.) |