| Transmission bracket to manual transmission |
Hexagon-head bolts, M10 x 1.5 x 55 with 20-mm spacer sleeves/always use new bolts following removal |
Initial tightening |
30 Nm (22 ftlb.) |
|
|
| Transmission bracket to manual transmission |
Hexagon-head bolts, M10 x 1.5 x 55 with 20-mm spacer sleeves/always use new bolts following removal |
Final tightening |
+60° |
|
|
| Transmission bracket to PDK transmission |
Hexagon-head bolts, M10 x 1.5 x 30/always use new bolts following removal |
Initial tightening |
30 Nm (22 ftlb.) |
|
|
| Transmission bracket to PDK transmission |
Hexagon-head bolts, M10 x 1.5 x 30/always use new bolts following removal |
Final tightening |
+40° |
|
|
| Transmission mount (hydraulic mount) to transmission bracket (all versions) |
Torx nut M12 x 1.5/the tightening torque must be supported using a open-ended wrench on the face of the transmission bracket (outside on the welded-on bush) |
Tightening torque |
85 Nm |
|
|
| Transmission mount (hydraulic mount) to rear-axle carrier side section (all versions) |
M8/differing screw lengths depending on variant |
Tightening torque |
33 Nm |
|
|