Brake Calliper
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Brake lines to brake calliper (front and rear axle) | M10 x 1 | Tightening torque | 16 Nm (12 ftlb.) | ||
| Ventilation valve to brake calliper | M10 x 1 | Tightening torque | 14 Nm (10.5 ftlb.) | ||
| Connecting line to brake calliper | M10 x 1 | Tightening torque | 16 Nm (12 ftlb.) | ||
| Brake calliper to wheel carrier, front and rear axle (PCCB and grey cast-iron brakes) | M12 x 1.5/always use new screws on front and rear axle following removal. Different screw length on front and rear axle . | Tightening torque | 85 Nm (63 ftlb.) |