Installing Guide Sleeve

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before re-installation: Clean the guide sleeve, transmission input shaft and release lever, particularly at the lubrication points.
We recommend that you use brake cleaner as the cleaning agent.

Fit guide sleeve.
1. 1.1. Position the guide sleeve.
2. 1.2. Tighten fastening screws -1- . Tightening torque 24 Nm (18 ftlb.)
  
  Fig 1: Identifying Screws For Guide Sleeve
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 1.3. Lubricate the guide sleeve with a light coating of Kluberalfa HM83-801. Lubrication point: -arrow- .
  
  Fig 2: Locating Lubrication Point
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Grease the splines of the transmission input shaft with Longtime 3EP.
Lubricate the contact points on the release lever with a light coating of Kluberalfa HM83-801. Lubrication points: -arrows- .

Fig 3: Locating Lubrication Contact Points
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit release lever and release bearing.

Fig 4: Fitting Lever And Bearing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. -A- : Position release lever -1- together with the release bearing -2- .
2. 4.2. -B- : Engage wire spring -3- in the opening on the release lever from behind.