Removing Front Brake Disc
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Installation of brake pads with the wrong brake pad quality
- Longer braking distance
- More wear on brake pads
→ Only use the type-specific brake pads listed in the Porsche Parts Catalogue.
→ Replace the brake pads when the brake pad wear indicator light comes on, but no later than when there is a residual pad thickness of 2 mm on each axle.
→ Replace the brake discs on each axle as soon as the brake pad wear limit is reached.
Information
- In order to gain better access for removal of the brake calliper, it is beneficial to turn the wheels fully either to the right or the left.
- Release holder for wear indicator connector on wheel carrier.
- Disconnect the speed sensor (ABS sensor).
- Push brake pads back slightly and evenly using the piston resetting fixture Nr.144 (-Direction arrow-) . Make sure that no brake fluid runs out of the supply tank - drain it if necessary.
- Undo brake calliper on wheel carrier and hang it in a suitable place in the wheel well (do not open the brake hydraulics!).
- Remove brake disc after unscrewing the fastening screw. If necessary, remove the brake disc by hitting it gently with a rubber hammer.