LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Boxster GTS, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (66 - Exterior Equipment -- 911 CARRERA (991)) >> WM 663119 Removing And Installing Door Entry Guard (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Installing Door Entry Guard

Installing Door Entry Guard

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order to removal.
  2. Check that the door entry guard is seated exactly. Check gaps and gap dimensions.
  3. Fastening screw on body, front. Tightening torque 3 Nm (2 ftlb.) 
  4. Fastening nut securing wheel housing liner to body. Tightening torque 3 Nm (2 ftlb.) 
  5. Fastening screw, rear, underside. Tightening torque 2 Nm (1.5 ftlb.) 
scientia non olet · About LEMON Manuals