Removing Spoiler Air Supply Module

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Air hoses are color-coded and must not be interchanged.

Observe marking for insertion depth of hose connection.

Hoses must not be kinked.

Fig 1: Identifying Air Supply Module Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unclip air deflection vane -1- and swivel it downwards.

Fig 2: Removing Air Deflector Vanes
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull hose connections down through the opening and disconnect them at the hose connections -1- .

Fig 3: Disconnecting Hose Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fold trim panel -1- for luggage compartment at the right aside.

Fig 4: Identifying Trim Panel For Luggage Compartment Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew and remove fastening screws -1- on the air supply module.

Fig 5: Identifying Air Supply Module Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fold module -1- inwards, release electric plug connection and pull off connector -arrow- .

Fig 6: Removing Electric Plug Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip air hose -1- from the clips.

Fig 7: Identifying Air Hose With Clips
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Carefully pull out air hoses with a rubber sleeve -1- .

Fig 8: Pulling Out Air Hose
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove spoiler air supply module.