Installing Front Spoiler (At The Left And Right)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Carefully clean any dirt, grease, wax and other impurities off the installation area of the body using isopropanol.
- Always use a clean cloth.
- The room and object temperature must be at least → Nominal value: +15°C.
- Humidity should be → Nominal value: 50 %+/-10 %.
- Do not touch the bonding surface again after removing the protective paper.
- Wear clean gloves during the bonding process in order to guarantee adequate adhesion.
- The parts must have been bonded for at least → Nominal value: 72 h before washing the vehicle in a car wash.
- Installation is performed in reverse order to removal.
- Tighten fastening screws on the front apron to Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 % .