Installing PDK Transmission Control Unit

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

If you are replacing the PDK transmission control unit, slide the new PDK transmission control unit into the holder.
1. 1.1. Carefully slide the PDK transmission control unit -1- into the holder -2- without tilting it -A- until the locks on the holder engage securely -B- .
  
  Fig 1: Sliding PDK Transmission Control Unit Into Holder
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect electric plug connections.
1. 2.1. Connect electric plug connection -1- (-A- ) and swivel in the swivel bolt at the same time until the connector locks securely.
2. 2.2. Connect electric plug connection -2- (-B- ) and swivel in the swivel bolt at the same time until the connector locks securely.
  
  Fig 2: Connecting Plug Connections
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install PDK transmission control unit.
1. 3.1. Insert PDK transmission control unit -A- and slide it in as far as it will go against the direction of travel -B- .
2. 3.2. Secure the PDK transmission control unit with the fastening screw -2- (-C- ). Tightening torque 2.5 Nm (2 ftlb.)
  
  Fig 3: Securing PDK Transmission Control Unit
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.