Preliminary Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

For all assembly work, observe the separate references for vehicles with PDCC.

Place cover in service position.
Unclip cover at the left and right, raise it and engage the yellow support in the luggage compartment lid -1- .

Fig 1: Placing Cover In Service Position
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
For all-wheel drive: Before raising the vehicle, loosen the drive shaft mounting at the wheel side. Get another mechanic to help by operating the brake.
Raise the vehicle.
→ 4X00IN LIFTING THE VEHICLE .
Remove wheel.
→ 440519 REMOVING AND INSTALLING WHEEL .
For all-wheel drive: Carefully press the drive shaft journal out of the wheel hub (approx. 10 mm) until the shaft can be moved by hand.
Use puller set Nr.87-1 Pos.1 together with pull stud Nr.87-1 Pos.2 to do this.

Fig 2: Installing Shaft Puller
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove brake calliper (do not open the brake system) and suspend it in the wheel arch.
→ 473919 REMOVING AND INSTALLING BRAKE CALLIPER .

→ 473919 REMOVING AND INSTALLING FRONT PDCC BRAKE CALLIPER .
Remove brake disc.
→ 465019 REMOVING AND INSTALLING FRONT BRAKE DISC .

→ 465119 REMOVING AND INSTALLING FRONT PDCC BRAKE DISC .