LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Boxster GTS, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (46 - Brakes - Brake Mechanics -- CARRERA (997)) >> WM 460519 Removing And Installing Brake Pedal (All Models) >> Removing Clutch Pedal And Brake Pedal >> Removing Clutch Pedal

Removing Clutch Pedal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove lid and side trim panel on fuse box.

    Installation position: In driver's footwell at the left.

  2. Carefully pull off the connector from the clutch pedal switch (and interlock switch if necessary), see -arrows-  .
    Fig 1: Locating Clutch Pedal Switch Connector
    G09825999Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Remove device support.

    The device support is installed at the left next to the clutch pedal together with the vehicle electrical system control unit and relay carrier.

    1. 3.1. Remove relay carrier.
    2. 3.2. Remove vehicle electrical system control unit.
    3. 3.3. Remove device support.
  4. Secure clutch power spring.
    WARNING: Preloaded or pressurized components
    • Risk of squashing or bruising

    → Do not reach into the danger area.

    → Relieve the tension on components before starting work.

    → Secure components to prevent them from loosening suddenly.

    Secure clutch power spring using a cotter pin, for example. Press the clutch pedal lightly, then unclip and remove the clutch power spring.

  5. Remove clutch master cylinder -arrows-  and pin (master cylinder valve pushrod) - do not open the clutch system.
    Fig 2: Locating Clutch Master Cylinder
    G09826000Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Remove bracket for clutch power spring.

    Information 

    When removing the bracket for the clutch power spring, carefully guide the master cylinder valve pushrod past at the clutch pedal.

    (Also remove clutch pedal switch and interlock switch, if necessary) → Bracket for clutch power spring  . Carefully move bracket for clutch power spring approximately 2-4 mm to the left -A-  . Carefully turn bracket for clutch power spring clockwise on the pedal bearing axle approximately 10-15 degrees -B-  . Remove bracket for clutch power spring to the left.

    Fig 3: Removing Clutch Power Spring Bracket
    G09826001Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals