Technical Values: Overview
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Threaded connection securing brake calliper to front and rear axle, M12 x 1.5 | Always replace screws on front and rear axle following removal. | Tightening torque | 85 Nm (63 ftlb.) | ||
| Retaining pin for brake pads for 6-piston brake callipers, M8 | Always replace screw following removal. | Tightening torque | 30 Nm (22 ftlb.) | ||
| Threaded connection securing brake disc to wheel hub (front and rear axle), M6 | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Threaded connection securing brake cover plate to front and rear axle, M6 | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Threaded connection securing speed sensor to front and rear axle, M6 | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Threaded connection securing brake hose bracket to wheel carrier (front and rear axles), M6 | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Combination plug connection (plug-in coupling) to wheel carrier (front and rear axles), M6 | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Threaded connection securing brake unit to body (aluminum interm. part), M8 | Tightening torque | 23 Nm (17 ftlb.) | |||
| Threaded connection securing brake unit support to body, M8 | Tightening torque | 23 Nm (17 ftlb.) | |||
| Threaded connection securing parking brake console to body, M8 | Tightening torque | 23 Nm (17 ftlb.) | |||
| Threaded connection securing bracket for hydraulic unit to body, M6 | Tightening torque | 4 Nm (3.0 ftlb.) | |||
| Threaded connection securing hydraulic unit to holder, M6 | Tightening torque | 5.5 Nm (4.0 ftlb.) | |||
| Brake pedal to brake pushrod (M8 x 1 threaded bolt) | Always replace threaded bolt following removal | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Brake pushrod to brake booster (collar nut M6) | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Brake pushrod to adjusting piece (lock nut) M12 x 1.5 | Tightening torque | 30 Nm (22 ftlb.) | |||
| Pedal bearing axle in pedal block | Tightening torque | 8to10 Nm (6 to 7.5 ftlb.) | |||
| Locknut pedal bearing axle to pedal block right M8 | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Locknut pedal bearing axle to pedal block left M14 | Tightening torque | 46 Nm (34 ftlb.) |