Preparing Connection Areas Of Body For Installing Rear Side Panel
- Straighten sealing surface and connection areas of the body.
- De-burr connection areas and prepare for welding.
Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive .
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed .
- Do not begin bonding work until all materials and tools necessary for later repair work are available .
- Prepare marked areas for welding and bonding.
Green Resistance spot-welding Yellow Resistance spot-welding + bonding Red Plug-welding/apply a full weld using inert gas without bonding