LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (66 - Exterior Equipment -- 911 CARRERA (991)) >> WM 665619 Removing And Installing Ventilation Grille For Lid (Upper) (Gt3 RS) >> Installing Ventilation Grille For Lid (Upper)

Installing Ventilation Grille For Lid (Upper)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following: 

  1. Install additional brake light. → 947019 REMOVING AND INSTALLING ADDITIONAL BRAKE LIGHT
  2. Tighten fastening screws at the bottom of the rear lid to the specified torque. Tightening torque 5.6 Nm (4.5 ftlb.) 
  3. Tighten fastening screws at the back of the rear lid to the specified torque. Tightening torque 5.6 Nm (4.5 ftlb.) 
scientia non olet · About LEMON Manuals