Subsequent Work
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Install wheel bearing housing with drive shaft fitted.
In other words: Contrary to the description → Installing Rear Wheel Bearing Housing , secure the drive shaft at the transmission (rather than fitting it on the wheel bearing housing).
- Install rear-axle cross member.
- Install cover for rear underbody.
→ 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY .
On the Cabriolet, also install the support plate.
- Fit wheel.
→ Installing Wheel .
- Check wheel alignment values. Make adjustments if necessary.