Installing Steering-Column Switch

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Slide the steering-column switch -2- with control unit for steering wheel electronics onto the steering column -3- (-arrow- ).
Tighten clamping screw -1- . → Tightening torque: 6 Nm (4.5 ftlb.)

Fig 1: Tightening Steering-Column Switch Clamping Screw

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Secure fixing clips (for wire harness) -arrows- .

Fig 2: Securing Steering-Column Switch Clip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Plug in electric plug connection -arrow- until it engages securely.

Fig 3: Installing Steering-Column Switch Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Plug in electric plug connection -arrow- until it engages securely.

Fig 4: Installing Steering-Column Switch Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.