LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 421419 Removing And Installing Support Plate (CARR. S CABRIO, CARR. CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, CARR. 4 GTS CABRIO, Turbo S CABRIO, Gt3, Gt3 RS) >> Removing Support Plate

Removing Support Plate

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle at the prescribed jacking points. → 4X00IN LIFTING THE VEHICLE .
  2. Loosen fastening screws -arrows-  and remove support plate.
    Fig 1: Locating Support Plate Screws
    G09992939Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals