Preliminary Work
WARNING: This page is about a different variant/trim than selected.
- Remove the engine.
- Remove transmission from engine.
> Refer to 343527 Removing and mounting transmission in the appropriate service information.
or
- Secure engine on assembly support.
> 1001IN SECURING ENGINE ON ASSEMBLY SUPPORT (MOUNTING BRACKET)
- Drain engine oil. For details, see
> 170117 DRAINING AND FILLING ENGINE OIL (CHANGING ENGINE OIL)
- Disassemble the engine. Cylinder heads are removed, but must remain intact. The starter, knock sensors, thermostat housing and coolant guide remain fitted on the crankcase. For details, see