Installing Spreader Device (EPB Actuator)

Information 

If new brake discs and/or new brake shoes are installed on the vehicle, they must be worn in before calibration (not PCCB!). → 468350 REWORKING PARKING-BRAKE SHOES 

If a new actuator was installed, it must be confirmed in the Porsche System Tester.

• >>Control unit overview<< >>Parking brake<< >>Drive links/Tests<< >>Confirm actuator replacement<<. 

1. Clean the actuator carefully so as not to damage the dust boots.
2. Visually inspect the dust boots for cracks.
3. Installation is performed in reverse order. Note: Do not twist brake shoe mountings when installing the actuator!

   EPB actuator to wheel carrier: Tightening torque 10 Nm (7.5 ftlb.) +60°