LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Panamera 4S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (28 - Ignition System, PREGLOW System 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 280419 Removing And Installing Ignition Switch >> Installing Ignition Switch

Installing Ignition Switch

WARNING: This page is about a different variant/trim than selected.
  1. Connect electric plug connection on the ignition starter switch until the connector engages securely.
    G15198954Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Connecting electric plug connection

  2. Position ignition starter switch in the dashboard from below -D-  . Fit union nut -1-  and slide it over the ignition starter switch. Check that it fits perfectly. Use special tool > 9800 - key-A-  to tighten the union nut > Tightening toque 1.6 Nm (1 ftlb.) 
    G15198955Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Turning union nut on ignition starter switch

scientia non olet · About LEMON Manuals