Removing Oil Level Sensor

WARNING: This page is about a different variant/trim than selected.

Fig 1: Oil Guide Housing With Accessories Components Location (2WD)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil guide housing with accessories (example for 2WD)

1	Screw, M6 x 20
2	Joint flange
3	Sealing ring
4	Oil guide housing to lower part of crankcase - aluminum screw; always use new aluminum screws
5	Oil level sensor
6	Oil level sensor to oil guide housing (steel screw)
7	Timing-case cover to oil guide housing - aluminum screw; always use new aluminum screws

Pull off electric plug connection -a- on the oil level sensor. Use the > T10118 - assembly tool if necessary.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil level sensor
Loosen fastening screws -arrows- and pull the oil level sensor out of the oil guide housing. Oil will start to drip.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screws
Replace sealing ring for oil level sensor.