LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Panamera 4S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (24 - Fuel System - Electronic Ignition 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 246319 Removing And Installing High-Pressure Pump >> Subsequent Work

Subsequent Work

WARNING: This page is about a different variant/trim than selected.
  1. Assemble plenum panel (fit cross panel).

    > WM 508119 REMOVING AND INSTALLING CROSS PANEL (DISASSEMBLING PLENUM PANEL) (EXCEPT PANAMERA EXECUTIVE, PANAMERA 4S SPORT EDITION, PANAMERA 4 EXECUTIVE)

  2. Fit the fuse for the fuel pump.
  3. Bleed the fuel high-pressure system. Erase the fault memory if necessary.
  4. Reset the high-pressure adaptation values and then carry out an adaptation drive. Carry out instructions in the same way as for replacing the DME control unit

    > 247055 REPLACING DME CONTROL UNIT 

scientia non olet · About LEMON Manuals