Fitting Rear Logo

Information 

• Carefully clean any dirt, grease, wax and other impurities off the installation area of the body using isopropanol. 
• Always use a clean cloth. 
• The room and object temperature must be at least  → Nominal value: +15°C. 
• Humidity should be → Nominal value: 50 %+/-10 %. 
• Do not touch the bonding surface again after removing the protective paper. 
• Wear clean gloves during the bonding process in order to guarantee adequate adhesion. 
• The parts must have been bonded for at least  → Nominal value: 72 h before washing the vehicle in a car wash. 

1. Insert the correct interchangeable insert -1-  into logo template - G1 9855 -2-  .

   The following interchangeable inserts -1-  can be selected:

   Interchangeable insert - G1 9855/1  , Interchangeable insert - G1 S 9855/2  , Interchangeable insert - G1 4 9855/3  , Interchangeable insert - G1 4S 9855/4  , Interchangeable insert - G1 turbo 9855/5  , Interchangeable insert - G1 turbo S 9855/6  , Interchangeable insert - G1 S Hybrid 9855/8  , Interchangeable insert - G1 GTS 9855/9 

   Fig 1: Preparing Logo Template

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Position the logo template -1-  on the vehicle.
   1. 2.1. Guide in logo template -1-  in the area -2-  between the rear lid and tail light -3-  .
   2. 2.2. Guide in logo template -1-  in the area -4-  between the rear lid and rear spoiler -5-  .
   3. 2.3. Secure logo template -1-  in area -6-  on the rear lid.
      Fig 2: Positioning Logo Template

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Remove protective paper from the logo -1-  .
4. Align the logo -1-  using the logo template -2-  and press it on firmly.
   Fig 3: Affixing Logo

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Remove logo template from the vehicle.