Installing Transmission Oil Cooler

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Replace molded seal.
Grease molded seal with a light coating of Khyber Syntheso Glep (Part No.: 000.043.204.68).

Fit transmission oil cooler.

Fig 1: Identifying Threaded Joint For Transmission Oil Cooler
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Position transmission oil cooler.
2. 1.2. Screw in and tighten screws (M6 x 55) -1- on the transmission oil cooler. Initial tightening 2.4 Nm (2 ftlb.)
3. 1.3. Screw in and tighten screws (M6 x 20) -2- on the transmission oil cooler. Initial tightening 2.4 Nm (2 ftlb.)
Secure cable duct for B+ line.

Fig 2: Identifying Cable Duct For B+ Line
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Position cable duct -1- .
2. 2.2. Screw in and tighten the two screws at the right -2- on the cable duct. Tightening torque 10 Nm (7.5 ftlb.)
Connect coolant hoses.

Fig 3: Identifying Spring Band Clamps
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Connect coolant hose -1- and close the spring band clamp -3- .
2. 3.2. Connect coolant hose -2- and close the spring band clamp -4- .
Hose clamping pliers Nr.192 -3- and -4- must now be removed from the two coolant hoses -1- and -2- .

Fig 4: Connecting Coolant Hose
Courtesy of PORSCHE CARS NORTH AMERICA, INC.