Installing Intake-Air Distributor - Side 4-6

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position intake-air distributor 4-6 with new molded seals on the cylinder head.
1. 1.1. Turn retaining clip for positive crankcase ventilation downwards before feeding it in.
2. 1.2. Insert intake-air distributor.
3. 1.3. Turn retaining clip into installation position and clip in line.
Secure intake-air distributor 4-6.
1. 2.1. Tool recommendation - 1/4 inch tool: ratchet, long extension, E10 Torx socket-wrench insert.
2. 2.2. Position the screws using a bar magnet because of the poor accessibility in some areas.
3. 2.3. Fit and tighten six screws according to the specified tightening sequence.
Install holder -3- for positive crankcase ventilation line.
1. 3.1. Fit and tighten two screws -2- .
2. 3.2. Clip in crankcase vent line -1- .
  
  Fig 1: Identifying Positive Crankcase Ventilation Line Holder
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.