Tightening Torques For Steering
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Tie rod (ball-joint pin) on lever M12 x 1.5 | Please note: Do not grease threaded connections in Dacromet finish - aluminum color. | Tightening torque | 75 Nm (56 ftlb.) | ||
| Aluminum tie rod to axial joint (lock nut) M14 x 1.5 | Please note: When using special tool P9730 (socket wrench insert), observe the changed tightening torque! 50 Nm (37 ftlb.) at the lock nut corresponds to a setting of approx. 32.5 Nm (24 ftlb.) on the torque wrench. | Tightening torque | 50 Nm (37 ftlb.) | ||
| Universal joint (steering shaft) to steering gear M8 x 35 | Please note: Do not grease threaded connections in Dacromet finish - aluminum color! Replace fit bolt after each removal. | Tightening torque | 23 Nm (17 ftlb.) | ||
| Steering gear to cross member, M10 x 1.5 | Please note: Do not grease threaded connections in Dacromet finish - aluminum color! Replace fastening screws following removal. | Tightening torque | 70 Nm (52 ftlb.) |