Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Hexagon-head bolt (cross member to front body), M14 x 1.5 x 120 | Tightening torque, M14 front | 160 Nm (118 ftlb.) | |||
| Hexagon-head bolt (cross member to rear body), M14 x 1.5 x 50 | Tightening torque, M14 rear | 160 Nm (118 ftlb.) | |||
| Hexagon-head bolt (cross member to front body), M12 x 1.5 x 30 | Tightening torque, M12 | 100 Nm (74 ftlb.) | |||
| Stud on front-axle cross member | Tightening torque | 20 Nm (15 ftlb.) | |||
| Fastening nuts on stud | Tightening torque | 65 Nm (48 ftlb.) | |||
| Spring-strut supporting mount to body, M8 | Tightening torque | 33 Nm (24 ftlb.) | |||
| Pressure and return lines to steering gear (tension shackle), M10 x 20 | Tightening torque | 23 Nm (17 ftlb.) | |||
| Universal joint (steering shaft) to steering gear, M8 x 35 | Tightening torque | 23 Nm (17 ftlb.) | |||
| Drive shaft to front-wheel drive halfshaft flange, M8 | All-wheel drive | Tightening torque | 39 Nm (29 ftlb.) | ||
| Longitudinal restraining straps for fuel tank cover | Observe installation position (marking L = left and R = right) | Tightening torque | 23 Nm (17 ftlb.) | ||
| Crash stop to body, M12 x 1.5 | Hexagon-head bolts | Tightening torque | 100 Nm (74 ftlb.) | ||
| Diagonal braces to front-axle cross member, M12 x 1.5 | Hexagon nuts | Tightening torque | 100 Nm (74 ftlb.) | ||
| Threaded joint securing brake calliper to wheel carrier, M12 x 1.5 | Replace bolts on front and rear axle each time they are removed. | Tightening torque | 85 Nm (63 ftlb.) | ||
| Suspension/stabilizer to anti-roll bar, M10 | Please note: Observe three-stage tightening procedure! Do not grease threaded connections in Dacromet finish - aluminum color. | Three-stage tightening procedure (1st stage: tighten to 50 Nm (37 ftlb.). 2nd stage: loosen by 90 degrees. 3rd stage: tighten to 65 Nm (48 ftlb.). | 65 Nm (48 ftlb.) | ||
| Brake hose bracket to wheel carrier, M6 | Tightening torque | 10 Nm (7.5 ftlb.) |