Attaching The Balance Stick-On Weights

Information 

• Remove the protective film just before sticking on the weight, as prolonged exposure to the air will reduce the bonding strength  .
• Pay attention to cleanliness  .

• Determine exact position of the balancing weights (if necessary, temporarily stick on the balancing weights with a strip of adhesive tape until the correct position is determined).
• Prepare bonding surface on the rim. The bonding surface must be perfectly clean and free of grease.
• Remove protective paper from the bonding surface of the weight and press the weight firmly into place.
• The balance stick-on weight must be in uniform contact over the entire surface.
• Check the balancing weight is seated firmly. A weight freshly affixed weight must not detach itself from the rim under application of a shear load at right angles to its longitudinal axis.