Removing Mounting Unit

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Mounting Unit Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pull wiring harness -1- out of the guide rail -2- .

Fig 2: Identifying Wiring Harness For Electric Drive
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew and remove fastening screws for outer -1- and inner front mounting unit -2- .

Fig 3: Removing Front Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew and remove fastening screws for rear mounting unit -1- .
1. 3.1. Unscrew and remove fastening screw -2- securing retaining bracket -3- to drive pipe.
  
  Fig 4: Identifying Rear Mounting Unit
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Information
  
  Secure square nut to prevent it from falling down.
Unscrew and remove fastening screws -1- securing mounting unit to assembly frame at the sides

Fig 5: Identifying Frame Mounting Assembly
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove safety clip -1- .

Fig 6: Identifying Safety Clip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove metal clip -1- using a suitable tool.

Fig 7: Identifying Metal Clip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Lift mounting unit -1- up and out -arrow- .

Fig 8: Lifting Out Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull mounting unit -1- with drive shaft forward and remove it -arrow- .

Fig 9: Pulling Out Mounting Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.