LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Cayman Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (53 - Body Rear - CARRERA (991)) >> WM 536919 Removing And Installing Rear Wheel Housing Liner (All Models) >> Installing Rear Wheel Housing Liner

Installing Rear Wheel Housing Liner

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

The brake spoiler is installed in reverse order. Pay particular attention to the following (GT3 only): 

  1. Tighten fastening screws to the specified torque. Tightening Torque 3 Nm (2 ft. lbs.) 

    The wheel housing liner is installed in reverse order. Pay particular attention to the following: 

  2. Tighten fastening nuts to the specified torque. Tightening Torque 2.7 Nm (2 ft. lbs.) +/-0.2 Nm (+/-0.1 ft. lbs.) 
  3. Tighten fastening screws to the specified torque. Tightening Torque 2.7 Nm (2 ft. lbs.) +/-0.2 Nm (+/-0.1 ft. lbs.) 
scientia non olet · About LEMON Manuals