Adjusting Rear Spoiler

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Spoiler wing position changed

Different vehicle handling

→ Move the additional wing to the lowest position for use on public roads.

→ The spoiler wing position may only be changed for race track driving.

Fig 1: Identifying Rear Spoiler Installation Position (Upper Part)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adjustment position 1 (road use)

Fig 2: Adjusting Rear Spoiler To Position 1 (Road Use)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Loosen fastening screw -1- .
2. 1.2. Unscrew fastening screw -2- .
3. 1.3. Swivel rear spoiler (upper part) to position 1 .
  Information
  - After making adjustments, the fastening screws must always be secured with Loctite 241 screw-locking lacquer.
4. 1.4. Screw in and tighten fastening screws to Tightening torque 9.7 Nm (7.5 ftlb.) .
Adjustment position 2 (race track use)

Fig 3: Adjusting Rear Spoiler To Position 2 (Race Track Use)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Loosen fastening screw -1- .
2. 2.2. Unscrew fastening screw -2- .
3. 2.3. Swivel rear spoiler (upper part) to position 2 .
  Information
  - After making adjustments, the fastening screws must always be secured with Loctite 241 screw-locking lacquer .
4. 2.4. Screw in and tighten fastening screws to Tightening torque 9.7 Nm (7.5 ftlb.) .
Adjustment position 3 (race track use)

Fig 4: Adjusting Rear Spoiler To Position 3 (Race Track Use)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Loosen fastening screw -1- .
2. 3.2. Unscrew fastening screw -2- .
3. 3.3. Swivel rear spoiler (upper part) to position 3 .
  Information
  - After making adjustments, the fastening screws must always be secured with Loctite 241 screw-locking lacquer .
4. 3.4. Screw in and tighten fastening screws to Tightening torque 9.7 Nm (7.5 ftlb.) .