Installing Gas-Discharge Control Unit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert control unit into the bracket until it engages securely.

Fig 1: Inserting Control Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in the fastening screws -5- for securing the control unit in the bracket.

Fig 2: Identifying Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push on electric connector -4- for the gas-discharge control unit until the connector engages securely.

Fig 3: Connecting Electric Plug
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press cable for gas-discharge headlight into the terminal -3- .
Connect electric connector -2- and turn it clockwise as far as it will go (bayonet lock).

Fig 4: Pressing In Cable For Gas-Discharge Headlight

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position control unit bracket and secure with the three fastening screws -1- .

Fig 5: Identifying Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Push on electric connector -4- for the gas-discharge control unit until the connector engages securely.

Fig 1: Connecting Electric Plug
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert the control unit into the lid of the headlight and secure with the fastening screw -3- .

Fig 2: Screwing In Fastening Screw For Control Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the gas-discharge headlight cable into the terminal in the lid.

Fig 3: Pressing In Gas-Discharge Headlight Cable
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide on the coil and screw in the fastening screws for the coil -2- and cable holder -1- .

Fig 4: Sliding On Coil And Screwing In Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.