WM 481019 Removing And Installing Steering Wheel (Except Turbo S Coupe "Ed. 918 SPYDER", CARRERA 4 GTS, Turbo S CABRIO "Ed. 918 SPYDER", CARRERA 4 GTS CABRIO, Gt3 RS 4.0): Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The steering wheel is made of magnesium alloy. The tightening torques must be strictly observed.
- Wheels straight ahead and observe the previously-applied markings.
- Always replace multiple-tooth screw following removal (micro-encapsulated thread).
- Observe specified tightening torque. → Tightening torque + torque angle: 30 Nm (22 ftlb.)+90°
- Airbag unit must lock with an audible click! Check by pulling on the airbag unit.
The steering wheel is installed in reverse order.