Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Stud on front-axle cross member | Tightening torque | 20 Nm (15 ftlb.) | |||
| Fastening nut on stud | Tightening torque | 65 Nm (48 ftlb.) | |||
| Drive shaft | Fastening screws between drive shaft and transmission flange | Tightening torque | 39 Nm (29 ftlb.) | ||
| Drive shaft to wheel hub | Before installing the drive shaft, use Optimoly HT to lightly grease the toothing and thread. Use a new lock nut | Tightening torque | 460 Nm (340 ftlb.) | ||
| Retaining strap securing cover to body | Tightening torque | 23 Nm (17 ftlb.) | |||
| Diagonal brace | Tightening torque | 100 Nm (74 ftlb.) |