Tightening Torques For Axle Strut
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Control arm to cross member/side member, M12 x 1.5 | Please note: Do not grease threaded connections in Dacromet finish - aluminum color. | Tightening torque | 120 Nm (89 ftlb.) | ||
| Control arm to diagonal arm, M14 x 1.5 | Please note: Do not grease threaded connections in Dacromet finish - aluminum color. | Tightening torque | 160 Nm (118 ftlb.) | ||
| Control arm to wheel carrier (ball joint), M12 x 1.5 (also applicable for 911 GT3) | Please note: Do not grease threaded connections in Dacromet finish - aluminum color. | Tightening torque | 75 Nm (56 ftlb.) | ||
| Camber basic setting on two-part trailing arm, M8 (911 GT3) | Please note: Do not grease threaded connections in Dacromet finish - aluminum color. | Tightening torque | 27 Nm (20 ftlb.) |