| No. 1: Holder to hydraulic unit |
M6 x 10 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Fastening screws securing hydraulic unit holder to body |
|
Tightening torque |
5 Nm (3.5 ftlb.) |
|
|
| No. 1, 2, 3, 6: Brake pressure pipe to hydraulic unit |
M10/M12 thread |
Tightening torque |
14 Nm (10.5 ftlb.) |
+/-1 Nm (+/- 0.5 ftlb.) |
|
| No. 4, 5: Brake pressure pipe to hydraulic unit |
M12 thread |
Tightening torque |
18 Nm (13 ftlb.) |
+/-2 Nm (+/- 1.5 ftlb.) |
|
| Cap screws for brake lines |
M10 x 1 thread |
Tightening torque |
14 Nm (10.5 ftlb.) |
+/-1 Nm (+/- 0.5 ftlb.) |
|
| No. 1: Combination sensor |
M6 thread (always replace screws and lock nuts after removal) |
Tightening torque |
8 Nm (6 ftlb.) |
|
|
| Speed sensor to front and rear axles |
M6 x 16 thread |
Tightening torque |
8 Nm (6 ftlb.) |
|
|