Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Threaded connection securing brake calliper to front-axle 19-inch wheel carrier and PCCB | M14 x 1.5 x 135 thread (always replace screws and lock nuts after removal) | Tightening torque | 140 Nm (104 ftlb.) | ||
| No. 4: Cable holder to front-axle wheel carrier | M6 x 12 thread | Tightening torque | 9 (6.5 ftlb.) Nm | ||
| No. 5: Brake hose holder to front-axle wheel carrier | M8 x 14 thread | Tightening torque | 20 (15 ftlb.) Nm | ||
| No. 6: Fastening screw securing brake disc to wheel hub | M12 x 1.5 thread (always replace screws and lock nuts after removal) | Tightening torque | 15 (11 ftlb.) Nm |