Mount For Fuel Distributor Pipe
WARNING: This page is about a different variant/trim than selected.
Mounting for fuel distributor pipe
TIGHTENING TORQUE SPECIFICATIONS
| 1 | Screw. M6 x 16 > Tightening torque 10 (7.5 ftlb.) Nm -- dang -- |
| 2 | Screw. M6 x 25 > Tightening torque 10 (7.5 ftlb.) Nm -- dang -- |
| 3 | Connection for high-pressure line |
| 4 | Connection to injector (high-pressure fuel injector): in 3 turns (tighten. loosen, tighten) > Tightening torque 25 (19 ftlb.) Nm -- dang -- |