Removing Belt TENSIONER
WARNING: This page is about a different variant/trim than selected.
Information
The pictures shown in this document may differ from the original.
Component overview of drive belt rollers (shown as an example in illustration)
| 1 | Deflection roller, cylinder bank 1-4 |
| 2 | Tensioning roller |
| 3 | Holder for deflection roller |
| 4 | Fastening screw for damper |
| 5 | Holder for tensioning roller |
| 6 | Damper/tensioner; bellows must be facing upwards. Observe code on the component. |
| 7 | Deflection roller, cylinder bank 5-8 |
| 8 | Sheetmetal holder |
- Loosen the bottom fastening screw on the belt tensioner damper.
- Loosen the top fastening screw on the belt tensioner.
- Remove belt tensioner.